In RawDigger, we use a 4圆 grid to extract average RAW values from 24 patches of Color Checker. The software can read files from any media, from a flash card to a network server. The current code is an improvement as otherwise, the dynamic range values would be lower for all ISOs and this would restrict the apparently available exposure range. DPReview keep a pretty good studio set-up, so lets take their studio scenes, made with 4 Canon cameras (Canon 5D Mark III, Canon 5D Mark IV, Canon 5DS, Canon 5DSr), and feed them to RawDigger (Profile Edition or Trial). The equation below is one of the more commonly understood definitions of the average: Average Sum Count where the sum is the result of adding all of the given numbers, and the count is the number of values being added. RawDigger supports all raw formats (including DNG) associated with a list of more than 800 supported cameras, and frequent updates are made to support new DSLR and cell phone models. so the value should be expected to be close to the value at 200. RawDigger doesn’t alter the raw data in any way. RawDigger is a microscope of sorts that lets you drill down into raw data both on Mac OS X and Windows. My quick and not-statistically validated test give a very similar noise level at ISO 100 and 200 (7 % lower standard deviation - 13% lower squared standard deviation). RawDigger is a tool allowing to view, study, and analyze pure raw data as recorded by digital photo- and certain video cameras. Scaling the Bill Claff number would give 11.34 at ISO 100 The histograms and zebra blinkies, at least on the sony gear, are really conservative. I have found, at least on my sony gear, I can expose at least a stop, sometimes a little more than a stop, than the camera says and still have no blown highlights in rawdigger. The red and the blue peak around 3000 to 3500 counts. If I use RawDigger it tells me that my green channel peak between 80 out of 16000 counts. Scaling the clarkvison number to match DxO at ISO200 would give 10.75 at ISO 100 I use rawdigger at home while processing. The RawDigger seems to work but I cant export the file as a high res TIF image and maintain the RGBG 2x2 square pixels. Rawdigger or pixinsight for flat counts - posted in DSLR, Mirrorless & General-Purpose Digital Camera DSO Imaging: I decided to check my flats counts ( it is lower than I expected) for my unmodified Sony a7s (14 bit deep). Still leaves the question of what is the correct value for ISO100 dynamic range in the magic lantern code. On the 50D, ISO 100 appears (subject to a statistical validation of the quick test here) to be a native ISO for the camera with lower noise than ISO 200 and is a valid selection for shooting. When photographing weddings, photographers often average between 15 images, and those who photograph sports and wildlife can potentially end up with many more. The example shown on for the 5D2 at ISO 50 shows a much greater noise (standard deviation) at ISO 50 which is why it considered a non-native ISO. This quick test shows lower standard deviation at ISO 100 with the same signal (Green average value).
0 Comments
Leave a Reply. |